Suzuki Baleno Manual page 2039

5) Remove lip type seal from front head.
1. Front head
2. Bearing puller
INSTALLATION
1) Press-fit lip type seal into front head using special tool (E).
Special Tool
(E): 09991-06050
CAUTION:
Do not reuse lip type seal once removed from com-
pressor.
1. Lip type seal
2. Front head
2) Coat special tool (F) surface with compressor oil and install it to
the shaft.
Special Tool
(F): 09991-06040
3) Install O-ring to case.
4) Apply compressor oil to lip type seal and O-ring.
5) Install front head assembly.
1. Front head
2. O-ring
6) Tighten front head bolt as specified torque.
Tightening Torque
(a): 14 N·m (1.4 kg-m, 10.5 lb-ft)
(b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
NOTE:
D Be sure to use new front head bolt and washer.
D Tighten bolt (a) first, and next (b).
1. Case
2. Front head
AIR CONDITIONING (OPTIONAL) 1B-15