Suzuki Baleno Manual page 1643

[1.3L and 1.6L engine models]
[1.8L engine model]
1. Radiator cap
2. Ear
3. Reservoir tank hose
4. Inlet hose
4) Using a pressure tester, check system and radiator cap for prop-
er pressure holding capacity 0.9 kg/cm
placement of cap is required, use proper cap specified torque
for this vehicle.
NOTE:
After installing radiator cap to radiator, make sure that its
ear is aligned with reservoir tank hose as shown in figure.
If not, turn cap more to align its ear with hose.
5) Tighten hose clamps and inspect all hoses. Replace hoses
whenever cracked, swollen or otherwise deteriorated.
6) Clean frontal area of radiator core.
COOLING SYSTEM FLUSH AND REFILL
1) Remove radiator cap when engine is cool:
Turn cap counterclockwise slowly until it reaches a "stop".
(Do not press down while turning it.)
Wait until pressure is relieved (indicated by a hissing sound)
then press down on cap and continue to turn it counterclock-
wise.
WARNING:
To help avoid danger of being burned, do not remove
radiator cap while engine and radiator cap while en-
gine and radiator are still hot. Scalding fluid and steam
can be blown out under pressure if cap is taken off too
soon.
2) With radiator cap removed, run engine until upper radiator hose
is hot (this shows that thermostat is open and coolant is flowing
through system).
ENGINE COOLING 6B-11
2
(12.8 psi, 90 kPa). If re-