Suzuki Baleno Manual page 1531

1. Gaging plastic
2. Scale
5) Using gaging plastic, check bearing clearance with newly se-
lected standard bearing.
If clearance still exceeds its limit, use next thicker bearing and
recheck clearance
6) When replacing crankshaft or cylinder block due to any reason,
select new standard bearings to be installed by referring to nu-
merals stamped on new crankshaft or alphabets stamped on
mating surface of new cylinder block.
UNDERSIZE BEARING (0.25 mm):
D 0.25 mm undersize bearing is available, in five kinds varying in
thickness.
To distinguish them, each bearing is painted in the following col-
ors at such position as indicated in figure. Each color represents
following thicknesses at the center of bearing.
1.3liter
Color painted
Green & Red
Black & Red
Red only
Yellow & Red
Blue & Red
1. Paint
1.6 leter
Color painted
Green & Red
Black & Red
Red only
Yellow & Red
Blue & Red
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-71
Bearing thickness
2.121 – 2.125 mm
(0.0835 – 0.0837 in.)
2.124 – 2.128 mm
(0.0836 – 0.0838 in.)
2.127 – 2.131 mm
(0.0837 – 0.0839 in.)
2.130 – 2.134 mm
(0.0839 – 0.0840 in.)
2.133 – 2.137 mm
(0.0840 – 0.0841 in.)
Bearing thickness
2.123 – 2.127 mm
(0.0836 – 0.0837 in.)
2.126 – 2.130 mm
(0.0837 – 0.0839 in.)
2.129 – 2.133 mm
(0.0838 – 0.0840 in.)
2.132 – 2.136 mm
(0.0839 – 0.0841 in.)
2.135 – 2.139 mm
(0.0841 – 0.0842 in.)