Suzuki Baleno Manual page 1652

6B-20 ENGINE COOLING
1. Oil level gauge guide
2. Generator adjusting arm
1. Water pump
INSPECTION
Check radiator for leakage or damage. Straighten bent fins, if any.
CLEANING
Clean frontal area of radiator cores.
INSTALLATION
Reverse removal procedures.
NOTE:
D Refill cooling system with proper coolant referring to
COOLANT item of MAINTENANCE.
D With automatic transmission vehicle, fill A/T fluid up to spe-
cified level. (For procedure to check A/T fluid and its level,
refer to SECTION 7B or 7B1).
D After installation, check each joint for leakage.
WATER PUMP
FOR 1.3L AND 1.6L ENGINE MODELS
REMOVAL
1) Disconnect negative cable at battery.
2) Drain cooling system.
3) Remove timing belt and tensioner according to procedure de-
4) Remove generator adjusting arm.
3. Generator
5) Remove oil level gauge guide with oil level gauge.
6) Remove water pump, gasket and rubber seal.
2. Gasket
scribed in item "TIMING BELT AND TENSIONER" in Section
6A1.