Suzuki Baleno Manual page 1645

1. 10 kg (22 lbs)
2. Adjusting bolt
3. Pivot bolt
WATER PUMP BELT TENSION
WARNING:
Disconnect negative cable at battery before checking
and adjusting belt tension.
1) Inspect belt for cracks, cuts, deformation, wear and cleanli-
ness. If it is necessary to replace belt. Refer to "WATER PUMP
BELT" in this section.
2) Check belt for tension. Belt is in proper tension when it deflects
6 to 8 mm (0.24 – 0.31 in.) under thumb pressure (about 10 kg
or 22 Ib.).
Belt tension "a": 6 – 8mm (0.24 – 0.31 in.) as deflection
NOTE:
When replacing belt with a new one, adjust belt tension to
5 – 7 mm (0.20 – 0.27 in.).
3) If belt is too tight or too loose, adjust it to proper tension by dis-
placing generator position.
4) Tighten belt adjusting bolt and generator pivot bolts.
5) Connect negative cable at battery terminal.
ENGINE COOLING 6B-13