Suzuki Baleno Manual page 1661

6C-6 ENGINE FUEL
1. Fuel pump & level gauge lead wire coupler
2. Rear right seat belt
3. Grommet
1. Sub muffler
2. Three-way catalytic converter case
1. Fuel filler hose 3. Clamp
2. Breather hose 4. Filler neck
INSTALLATION
1. Filter
2. Bracket
1) Install filter bracket to filter.
3. Match mark
Be sure to align match marks on filter and bracket before tight-
ening bracket bolt.
2) Install filter.
3) Connect outlet and inlet hoses.
Clamp hoses securely.
4) Connect negative cable to battery.
5) With engine "OFF" and ignition switch "ON", check for fuel
leaks.
FUEL TANK
REMOVAL
1) Relieve fuel pressure in fuel feed line referring to SECTION 6.
2) Disconnect negative cable at battery.
3) Remove rear seat cushion, rear right seat back, right side sill
scuff, right front partition trim and right rear door opening trim.
4) Disconnect fuel pump and fuel level gauge wire at coupler.
5) Hoist vehicle.
6) Remove muffler.
7) Remove propeller shaft No.2 referring to SECTION 4B (4WD
only).
3. Mounting
8) Disconnect fuel filler hose and breather hose from filler neck.