Suzuki Baleno Manual page 1495

1. Timing belt side
2. Flywheel side
1. Indicates position from timing
belt side. Install in numerical
order starting from timing belt
side.
2. Indicates direction of housing.
Install so that arrow is directed
toward timing belt side.
1. Camshaft oil seal
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-35
7) Apply engine oil to cams and journals on camshaft and put cam-
shaft on cylinder head. Install camshaft housing to camshaft
and cylinder head.
D Apply engine oil to sliding surface of each housing against
camshaft journal.
D Apply sealant to mating surface of No.6 housing which will
mate with cylinder head.
"A": Sealant 99000-31110
D Embossed marks are provided on each camshaft housing,
indicating position and direction for installation.
Install housing as indicated by these marks.
D As camshaft housing No. 1 retains camshaft in proper posi-
tion as to thrust direction, make sure to first fit No. 1 housing
to No. 1 journal of camshaft securely.
D After applying engine oil to housing bolts, tighten them tempo-
rarily first. Then tighten them by the following sequence as indi-
cated in figure.
Tighten a little at a time and evenly among bolts and repeat tight-
ening sequence three to four times before they are tightened to
specified torque.
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
8) Install camshaft oil seal.
After applying engine oil to oil seal lip, press-fit camshaft oil seal
till oil seal surface becomes flush with housing surface.
9) Install timing belt inside cover.