Suzuki Baleno Manual page 1522

6A1-62 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
1. Mounting member
2. Left mounting
3. Right mounting
4. To front member
5. Suspension frame
28) Before removing engine with transmission from body, recheck
29) Lower engine with transmission from body.
INSTALLATION
1) Lift engine with transmission into engine compartment, but do
2) Install engine right mounting to right mounting bracket and
3) Install engine left mounting to body.
4) Install mounting member to front member and suspension
5) Install suspension frame with stabilizer bar to body, referring
6) Tighten bolts and nuts of all parts installed in above steps 2),
7) Remove lifting device.
8) Reverse removal procedures for installation of remainder.
6. To body
7. Right mounting
bracket
8. Right mounting
bracket stiffener
to make sure all hoses, electric wires and cables are discon-
nected from engine and transmission.
not remove lifting device.
stiffener.
frame (2WD).
to Section 3D (4WD).
3) and 4) or 5) to specified torque.
Tightening Torque
(a): 55 N·m (5.5 kg-m 40.0 lb-ft)
(b): 45 N·m (4.5 kg-m, 32.5 lb-ft)
(c): 23 N·m (2.3 kg-m, 17.0 lb-ft)
D Push in each drive shaft joint fully so that snap ring engages
with differential gear or center bearing support.
Use care not to damage oil seal lip when inserting.
D Clamp electric wire securely.
D Install propeller shaft to transmission case flange referring
to Section 4B (4WD).