Suzuki Baleno Manual page 1591

6A3-52 ENGINE MECHANICAL (J18 TYPE ENGINE)
VALVES AND CYLINDER HEAD
NOTE:
When removing and installing cylinder head, engine should be stable with front torque bush and rear
mounting installed to mounting member.
1. Accelerator cable
REMOVAL
1) Relieve fuel pressure according to procedure described in Sec-
tion 6.
2) Disconnect negative cable at battery.
3) Drain engine oil.
4) Drain coolant.
5) Remove ignition coil cover.
6) Remove air cleaner case with air cleaner outlet hose.
7) Disconnect accelerator cable from throttle body.
8) Disconnect the following hoses:
D Brake booster hose from intake manifold
D Canister purge hose from EVAP canister
D Water hose from throttle body
D Fuel feed hose from delivery pipe
D Fuel return hose from fuel pressure regulator
D Heater hose from water outlet cap
D Radiator inlet hose from water outlet cap
1. Cylinder block
2. Cylinder head
3. Cylinder head gasket
4. Intake valve
5. Exhaust valve
6. Valve spring seat
7. Valve springs
(Inner and outer)
8. Valve stem oil seal
9. Valve spring retainer
10. Valve cotter
11. Valve guide
12. Water outlet cap
13. Water outlet cap gasket