Suzuki Baleno Manual page 1601

6A3-62 ENGINE MECHANICAL (J18 TYPE ENGINE)
1. Match mark on crank timing sprocket
2. Mating surface of cylinder block and lower crankcase
1. Cylinder head gasket
2. Cylinder block
3. Knock pin
INSTALLATION
1) Match match mark on crank timing sprocket and mating surface
2) Clean mating surface of cylinder head and cylinder block.
3) Install knock pins to cylinder block.
4) Install new cylinder head gasket to cylinder block.
4. Camshaft pulley side
5. Flywheel side
5) Install cylinder head to cylinder block.
1. Crankshaft pulley side
2. Flywheel side
1. Crankshaft pulley side
2. Flywheel side
1. Crankshaft pulley side
2. Flywheel side
3. Bolt (M6)
of cylinder block and lower crankcase.
Remove oil, old gasket and dust from mating surface.
Apply engine oil to cylinder head bolts and tighten them gradual-
ly as follows.
(1) Tighten all bolts to 53 N·m (5.3 kg-m, 38.5 lb-ft) according to
numerical order in figure.
(2) In the same manner as in (1), retighten them to 84 N·m (8.4
kg-m, 61.0 lb-ft).
(3) Loosen all bolts until tightening torque is reduced to 0 ac-
cording to numerical order in figure.
(4) Tighten all bolts to 53 N·m (5.3 kg-m, 38.5 lb-ft) according to
numerical order in figure.
(5) In the same manner as in (4), retighten them to specified
torque.
Tightening Torque
(a): 105 N·m (10.5 kg-m, 76.0 lb-ft)
(b): 11 N·m (1.1 kg-m, 8.0 lb-ft)
NOTE:
Be sure to tighten M6 bolt after securing other bolts.