Suzuki Baleno Manual page 1644

6B-12 ENGINE COOLING
[1.3L and 1.6L engine models]
[1.8L engine model]
1. Radiator
2. Radiator drain plug
1. Reservoir tank
2. FULL level mark
3. LOW level mark
4. Reservoir tank cap
5. Match mark
3) Stop engine and open radiator drain plug to drain coolant.
4) Close drain plug. Add water until system is filled and run en-
gine until upper radiator hose is hot again.
5) Repeat steps 3) and 4) several times until drained liquid is
nearly colorless.
6) Drain system and then close radiator drain plug tightly.
7) Remove reservoir tank and remove cap from reservoir tank
and pour out any fluid, scrub and clean inside of tank with soap
and water.
Flush it well with clean water and drain. Reinstall tank.
8) Add 50/50 mixture of good quality ethylene glycol antifreeze
and water to radiator and tank.
Fill radiator to the base of radiator filler neck and reservoir tank
to "FULL" level mark. Reinstall reservoir tank cap and align
match marks on tank and cap.
9) Run engine, with radiator cap removed, until radiator upper
hose is hot.
10) With engine idling, add coolant to radiator until level reaches
the bottom of filler neck. Install radiator cap, making sure that
the ear of cap lines up with reservoir tank hose.