6A1-16 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
1. Exhaust manifold
1. Manifold nut
1. Exhaust manifold cover
3. Oxygen sensor
2. Clamp
1. Exhaust No.1 pipe
5) Remove exhaust manifold and its gasket from cylinder head.
6) Remove exhaust pipe gasket from exhaust No.1 pipe.
INSTALLATION
1) Install new gaskets to cylinder head and exhaust No.1 pipe.
2) Install exhaust manifold.
3) Install exhaust manifold covers.
4) Connect oxygen sensor coupler and clamp its wire securely.
coupler
5) Connect exhaust No.1 pipe to exhaust manifold.
6) Connect negative cable at battery.
7) Check exhaust system for exhaust gas leakage.
Tighten manifold bolts and nuts to specified torque.
Tightening Torque
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
Tightening Torque
(a): 50 N·m (5.0 kg-m, 36.5 lb-ft)