Suzuki Baleno Manual page 1489

1. Outer rotor
2. Inner rotor
1. No.1 bolts (short)
2. No.2 bolts (long)
ASSEMBLY
1) Wash, clean and then dry all disassembled parts.
2) Apply thin coat of engine oil to inner and outer rotors, oil seal lip
portion, and inside surfaces of oil pump case and plate.
3) Install outer and inner rotors to pump case.
4) Install rotor plate. Tighten 5 screw securely.
After installing plate, check to be sure that gears turn smoothly
by hand.
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
5) Apply engine oil to O-ring and install O-ring and guide.
1. Oil pump
2. Oil level gauge
guide
3. O-ring
INSTALLATION
1) Install two oil pump pins and oil pump gasket to cylinder block.
Use a new gasket.
2) To prevent oil seal lip from being damaged or upturned when
installing oil pump to crankshaft, fit special tool (Oil seal guide)
to crankshaft, and apply engine oil to special tool.
Special Tool
(A): 09926-18210
3) Install oil pump to cylinder block.
As there are 2 types of oil pump bolts, refer to figure for their cor-
rect use and tighten them to specified torque.
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-29