Suzuki Baleno Manual page 1570

1. Timing chain cover 3. Cylinder block
2. Cylinder head
INSTALLATION
CAUTION:
When raising engine, be careful not to raise it excessive-
ly and not to cause transmission to contact body, steer-
ing gear box, etc.
Reverse removal sequence to install timing chain cover noting the
following points.
1) Apply sealant "A" to area as shown in figure.
"A": Sealant 99000-31150
Width "a" : 3 mm, 0.15 in.
Height "b" : 2 mm, 0.1 in.
"B": Sealant 99000-31140
2) Apply engine oil to oil seal lip, then install timing chain cover.
Tighten bolts and nut to specified torque.
NOTE:
Before installing timing chain cover, check that pin is se-
curely fitted.
Tightening Torque
(a): 11.0 N·m (1.1 kg-m, 8.0 lb-ft)
1. Timing chain cover
2. Nut
3. Bolt
3) Install generator belt idler pulley.
Tighten nut to specified torque.
Tightening Torque
(a): 45 N·m (4.5 kg-m, 33.0 lb-ft)
4) Install generator belt tensioner.
Tighten bolts to specified torque.
Tightening Torque
(b): 25 N·m (2.5 kg-m, 18.5 lb-ft)
5) Install water pump pulley.
1. Generator belt
idler pulley
2. Generator belt
tensioner
3. Water pump pulley
ENGINE MECHANICAL (J18 TYPE ENGINE) 6A3-31