Suzuki Baleno Manual page 1549

6A3-10 ENGINE MECHANICAL (J18 TYPE ENGINE)
1. Air cleaner upper case
1. Air cleaner upper case
ON VEHICLE SERVICE
AIR CLEANER ELEMENT
This air cleaner element is dry type. Remember that it needs clean-
ing according to the following procedure.
REMOVAL
1) Remove air cleaner upper case from lower case after hooking
clamps from upper case.
2) Remove air cleaner element.
2. Clamp
INSPECTION
Check air cleaner element for dirt.
CLEANING
Blow off dust by compressed air from air outlet side of element.
INSTALLATION
1) Install air cleaner element to its lower case.
2) Install air cleaner upper case.
Hook clamps securely.
2. Clamp
AIR CLEANER OUTLET HOSE
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect IAT sensor wire at coupler.
3) Remove air cleaner outlet hose.
1. Air cleaner
outlet hose
2. IAT sensor
INSTALLATION
Reverse removal procedure for installation.
1) Install air cleaner outlet hose by aligning match marks as shown
in figure.
1. Air cleaner
outlet hose
2. Match mark