Suzuki Baleno Manual page 1589

6A3-50 ENGINE MECHANICAL (J18 TYPE ENGINE)
I: Intake side
E: Exhaust side
Position from timing chain side
Timing chain side
5) Install camshaft housing pins as shown in figure.
6) Apply sealant "A" to exhaust camshaft end housing sealing
1. Intake camshaft
2. Exhaust camshaft
3. Pin installation position
7) Check position of camshaft housings.
8) After applying oil to housing bolts, tighten them temporarily
9) Install CMP sensor.
10) Install 2nd timing chain.
11) Install timing chain cover.
12) Install cylinder head cover.
13) Install oil pan.
14) Install cooling system and other parts.
15) Refill cooling system with coolant and engine with engine oil.
16) Check ignition timing and adjust as necessary referring to Sec-
17) Check to make sure that there is no water leakage and oil leak-
surface area as shown in figure.
"A": Sealant 99000-31150
Embossed marks are provided on each camshaft housing, in-
dicating position and direction for installation. Install housings
as indicated by these marks.
first. Then tighten them by the following numerical order in fig-
ure. Tighten a little at a time and evenly among bolts and repeat
tightening sequence two or three times before they are tight-
ened to specified torque.
Tightening Torque
11 N·m (1.1 kg-m, 8.0 lb-ft)
Refer to Section 6F2 for CMP sensor installation.
Refer to item "2ND TIMING CHAIN AND CHAIN TENSIONER"
in this section for installation.
Refer to item "TIMING CHAIN COVER" in this section for
installation.
Refer to item "CYLINDER HEAD COVER" in this section for
installation.
Refer to item "OIL PAN AND OIL PUMP STRAINER" in this
section for installation.
tion 6F2.
age at each connection.