Porsche 928 Workshop Manual page 707

34
Manual Transmission/Controls, Case
928
DISASSEMBLING AND ASSEMBLING MANUALTRANSMISSION
Disassembling
1. Mount transmission on assembly stand with special
fool 9149 and drain transmission oil.
5. Remove circlip for countershaft and
take out
countershaft.
6. Remove circlip for input shaft.
2. Remove differential (see page 39 I).
3. Engage 5th gear. drive out roll pin IA1 for shift
finger and only then (when spring is relaxed) split
pin (B) for spring support.
Disassembling order is important, since otherwise
the accelerated split pin IB) could cause injury.
4. Drive out split pins for selector forks and remove
selector rods toward rear (toward differential).
7. Remove bearing cover by turning and pulling.
Remove O-ring and pull out input shaft with
special tools 9140 and 9148.
Note
Always first remove the countershaft and lower
cluster gear to bottom of transmission.
34.14 Disassembling and Assembling Transmission Printed in Germany