Porsche 928 Workshop Manual page 832

38
Automatic Transmission / Gears. Valve Body 0 28
DISASSEMBLING AND ASSEMBLING CLUTCH K 1
Disassembling Assembling
1. Install Special Tool 9309 on spring retainer
rhar pressure ring has an uniform fit. Press
down rhe spring retainer in a press far enough,
that snap ring is clear and can be removed.
1. Install lipped seal carefully that ir is positioned
correctly in the groove and its lip faces down
(in direction of arrow).
2. Release press carefully and remove spring re-
rainer and springs.
Note
Never use sharp edged rools [a install seals.
Note
The quantity of springs for the clutch pistons will
vary. If new springs are required. rhe same
quantity must be used again.
2. loser1 Special Tool 9309 in support flange.
3, Install lipped seal for piston that its sealing
lip faces down to borrom of support flange.
a
38 - 44
Disassembling and Assembling Clutch K 1
Printed in Germany