Porsche 928 Workshop Manual page 694

928 Manual Transmission/Controls. Care
34
ADJUSTING TRANSMISSION SUSPENSION
a
To prevent stress in transmission suspension and
to provide good insulation. transmission mounts
have to be adjusted.
1. Install transmission and rear axle. Tighten trans-
mission mount to transmission case bolts to spe-
cified torque.
2. Screw in cross member to transmission mount
bolts several turm.
3. Lift transmission at center of case enough so
that there is a gap between both transmission
mounts and the cross member. Measure this gap
on both sides and take up difference with shims.
9
..,
8I.Y.
I& nq;,,;
I,,,, .; -;,
1
,.
- ~., ,
I,' -
/
,..:I., ./I
.f s+>,..
'^'
"%z,+$JL ; .;#-\ ,+-
.
.*z& (~.,
+;$t,,
* ;:;:..:
r
:qy ",.
"a,-
'.: 'a
;.. 1,
" : '. ,;<, ",,,Q
4 Lo-
4. Place shims of determined thickness between
the transmission mount and cross member, low-
er transmission and tighten transmission mount
to cross member bolts to specified torque.
Note
There must he at least 1 mm clearance between
transmission case and side stop an transmission
mount after tightening the mounting bolts.
a
Printed in Germany - IV. 1980 Adjusting Transmission Suspension 34-8a