Porsche 928 Workshop Manual page 753

928
Automatic Transmission/Controls, Care
37
Note When: Special
NO. Description
Qfy. Removing
Installing Instructions
1
Circlip 1
2 Input flange 1
If replaced,
readjust
connection
between fly-
wheel and drive
plate
(page 39 .51)
3
Bolt 6
Torque:
M-64Nm
(39 - 46 ftlb)
4
Lockwasher 6
Replace. Position
correctly
5
Lockplate 1
8 Drive plate 2
See below
7
Grooved ball bearing 1
Press from output Replace. Install in
flange with VW 457
heated housing
together with
output flange
8 Spacer 1
9
Circlip 1
0
Grooved balls bearing
1
Drive out with
Replace. Heat
suitable mandrel
housing to approx.
120 'C and press
in with a suitable
piece of pipe.
Support input flange
11
Front converter housing
1
If replaced,
readjust
connection
between fly-
wheel and drive
plate (page
39-51)
Note
Two drive plates (each 1.5 mm thick) have replaced the single drive plate (2.0 mm thick).
In conjunction with this change the input flange (Pas. 2) also had to be modified.
Since spare parts of former version are no longer available, when repairing cars with only one drive plate
they must be changed to the new version.
Printed in Germany VI, 1982 Disassembling and Assembling Front Converter Housing 37-19