Porsche 928 Workshop Manual page 1092

37 Automatic Transmission/Controls, Case
928
20.Insert clutch K
1
while turning
until teeth engage.
21.Insert
brake band such that pin
is facing from assembly lock to
pressure unit B
1 (see
Step
19).
22.00 not insert axial bearing and
shims until axial play of clutch
K 1 has been measured.
23.Push pressure pin into pressure
unit 8 1 (replace O-rings).
24.Insert pressure unit, screw in
threaded plug or transmission
protection switch in '87 models
onward and tighten. Tightening
torque 70 Nm (52 ftlb).
"?Z
-.
? .e
.*. ,
f% a;= .4.
.,I
?
25.Insert
brake-band guide. The
locating pins must engage the
holes in the case.
26.Check axial play
K 1 and correct.
"B" for clutch
1 = Axial bearing
2 = Rotation washer
3 = Shim
B = Axial play
37 - 158 Disassembling and Assembling Transmission
Printed in Germany