Porsche 928 Workshop Manual page 653

30
Clutch, Controls
928
Installing
1. Slide clutch power spring and pertinent
parts on to guide rod. Insert piece of wire.
4543 ?
l 6 1
KLl,
efl'
L I.4
A Assembly bore
1 Bearing
2 Clutch power spring
1
3. Install adjusted complete part in car and
mount on clutch pedal.
4. Take piece of wire out of guide rod and ad-
just clutch pedal to final position.
5. Mount clutch push rod on pedal. Check
push rod adjustment and correct if required.
3 Spring retainer
4 Washer
5 Winged nut
6 Guide rod
7 Bearing sleeve
2. Adjust clutch power spring. Distance A be-
tween inside of spring retainer and center of
bearing shafl should be 43 mm*. If neces-
sary, correct by turning the winged nut.
* As of MY '92. dimension A is 21 mm. At the same time, the parts listed under #em 1 have been
modified.
30 - 2h
Removing and installing Clutch Spring
Printed in Germany - XXVII, 1991