Porsche 928 Workshop Manual page 759

0
928
Auromaric Transmission / Controls. Case
37
REMOVING AND INSTALLING FINAL DRIVE HOLISING AND
REAR CONVERTER HOLISING
Removing
1. Pull ou[ race wirh two approx. 60 mm long bolrs
and rake off final drive housing.
2. Screw IWO sraybolrs in rransmission case and
install gasket.
A Staybolrs
2. Turn transmission in assembly stand until con-
vener housing faces up.
3. Remove converter housing moonring bolls and
take off housing by applying light knocks wirh a
plastic hammer.
Installing
1. Install rhe number of shims noted while removing
or the shims calculared for the axial play on rhe
input shaft.
3. Align piston ring on input shaft that its gap is
flush with rhe groove.
4. Install convener housing and righren mounting
bolts IO the specified torque.
Note
l'se a sealanr (e. g. Hylomar SQ 32 M) on the lower
seven bolls. This sealanr remains permanenrly elastic
within a high remperarure range. Ir is available from
Marsron iilchemie GmbH in 5352 ZUlpich.
Printed in Germany - III. 1979
Removing and Installing Final Drive Housing
and Rear Converter Housing
37 - 25