Porsche 928 Workshop Manual page 692

34
Manual Transmission/Controls. Case
928
10. After stripping back the dust cover. remove set
scw# from shift rod coupling. Detach shift rod
by pushing it off of main shift rod.
11. Remove battery console (only for cars with
bolted battery console).
12. Pull off wires on backup lights. Remove pulse
transmitter for speedometer and both wires from
mounting clips,
.:
$
13. Detach axle shafts ar transmission end and sus-
pend from rear axle cross member in horizontal
position.
14. Disconnecr srabilizer bar at lower control arm.
15. Support transmission with special tool
US 8031 attached to stabilizer bar.
mv!B!!we
,,~&-L?~'~
'T-
, d J;.'; '._ ,
16. Remove both bolts of transmission mounts on
rear axle cross member as well as 2 bolts be-
tween rear axle cross member and frame.
To improve the insulating effect of transmission
mounts, (since March of 1980) rhe gap between the
transmission mounts and rear axle cross member is
measured during assembly and eliminated by in-
stalling shims.
For this reason the shims must be marked for in-
stallation later.
34 6
Removing and Installing Transmission
Printed in Germany