Porsche 928 Workshop Manual page 742

828
Automatic Transmission / Controls. Case
37
a
REMOVING AND INSTALLING SELECTOR LEVER CABLE
Removing
Norc
To remove the selector lever cable it will be
necessary to remove muffler and rear shield.
Further rhe rear axle has IO be removed up IO the
control arm mounrings and lowered (see page
31 - 2. "Removing and Installing Transmission").
1. Unscrew ground strap of battery.
6. DisconnecI selccror lever cable ar transmission
and derach cable sleeve ar holder.
2. Remove selector lever grip and rake off rubber
cover.
3. Remove cover frame (see page 31 - 10 a).
4. Pull bulb holder carrier out of retaining clips.
5. Mark locarion of selector lever base for rein-
srallaiion and remove mounting screws.
I. Take off ball head. hexagon nur and mounting
part*.
8. Mow wire on cable and pull out selecror lever
base by applying a jerk forwards. Lower cenual
tube and transmission slighrly for this purpose.
Printed in Germany - IV, 1'180
Removing and lnsralling Selector Lever Cable
37 - !$