Porsche 928 Workshop Manual page 1056

37
Automatic Transmission/Controls, Case 928
3. Install and slightly tighten accessible bolts
on central tube flange.
4. Lift transmission, remove block of wood and
take out brace again.
5. Lower transmission only far enough that
remaining bolts can be screwed in central
tube flange (tightening torque: 120 Nm/
a7
ftlb).
6. Mount guide tube for control cable on
converter housing (tightening torque:
8 Nm16 ftlb).
7. Push wire harness upwards through
opening in spare wheel well.
8. Lift transmission and hold in installed
position with Special Tool 9164.
9. Lower universal transmission jack.
10. Install rear axle and tighten all bolts
except for two transmission mount
bolts.
11. Lift transmission and disconnect Special
Tool 9164.
12. Adjust transmission suspension (see
page 37 - 123).
13. Mount transmission on cross member
(tightening torque: 85 Nm/61 ftlb).
14. Check adjustment of selector lever and
control pressure cables, correcting if
necessary.
a
37-122
Removing and Installing Transmission
Printed in Germanv