Porsche 928 Workshop Manual page 949

35
Manual Transmission/Gears and Shafts
928
a
DISASSEMBLING AND ASSEMBLING DRIVE SHAFT
Disassembling
1. Remove circlip.
2. Press off grooved ball bearing with a
pertinent pressure pad and Special
VW 457.
,!Lm.+n,
-@J:
/ !
ebA+pJp!nm-
p?L7 -..I
6
hi-we. w
Assembling
1. Heat grooved ball bearing to approx.
100° C / 212' F and drive on.
2. Check synchronizing ring by pressing
ring against taper of gear wheel and
measure gap "a" with a feeler gage blade.
Installed distance (new) = 0.9 to 1.5 mm
Wear limit
= 0.6 to 0.7 mm
a
35 - 204 Disassembling and Assembling
Drive Shaft
Printed in Germany