Porsche 928 Workshop Manual page 651

30
Clutch, Controls
928
Installing
1. Check needle bearing, bearing shaft, retainers,
stops, all sleeves and shafts, replacing if necessary.
Coat all bearing and sliding surfaces with a multi-
purpose grease.
2. Install pedals
Note:
Bearing shaft can only be pushed in fully, if
surfaces on bearing shaft and console are aligned
3. Place complete clutch power spring/guide rod in
console and mount on clutch lever.
4. Take assembly wire out of guide rod and move
clutch pedal to final stop.
5. Mount clutch and brake push rod on pedals.
Connect return spring for brake pedal. Check
push rod play, correcting if necessary.
See pages 30 1 and 46 9.
l
30.2f Removing and Installing Clutch Pedal
Printed in Germany