37
Automatic
Transmission/Controls,
Case
928
Installing
Note:
The outer seal on the rear transmission
between the transmission case and final
drive could be missing due to manufacturing
conditions.
1. Drive in outer seal (if not already installed)
to correct position with Special Tool
9180/i.
Note:
Outer seal must be installed that sealing lip
and spring supporting the sealing lip face
final drive.
2. Mount Special Tool 9301 on torque
converter.
3. Coat drive flange and bearing journal of
converter with a multi-purpose
grease
containing MoS, additives.
4. Position transmission upright and install
converter carefully, while turning con-
verter back and forth until splines mesh.
5. Check installed depth of converter (about
16 mm).
37
140
Removing and Installing Rear Transmission
Printed in Germany