Differential, Transaxle System
928
Assembly and dismantling
instructions
Dismantling
Relieve the lever disk (No. 7) by undoing the
adjusting nut (No. 5). Degrease the lever disk
and fix the segments for re-installation
with
adhesive tape.
A = Adhesive tape
Assembly
295-38
1. Determine the axial play of the axle bevel
gears and adjust to 0.05-0.15
mm by insert.
ing the corresponding
friction washers (No.
16/33).
Note
If parts (e.g. differential housing or bevel
gears) are replaced, the finished friction wash-
ers must be installed for measurement.
2. Drive in the clamping pins for the taper pin-
ion shafts in the correct position,
ItA4
297.39
39 - 212n
Dismantling and assembling the proportional-slip
differential
a
Printed in Germany - XXIV, 1989