Porsche 928 Workshop Manual page 743

37
Auromaric Transmission / Controls. Case
928
w--v
. _ '.I
:r; .'a
& -i'
.,,- 1
y&
.I
"ix ,_ ,i . ., .>
5. lnsrall cover frame and place seleaor lever
at "N".
If light opening of gate and letter "N" are nor
exacrly opposite each other in cover frame.
remove cover frame again and reposition selector
lever base in slots.
24 :'
ii
"$ )'
p. ,,
,pq&;yi'~
F
9. Remove cable circlip from selecror lever
and detach cable sleeve at selector lever
base.
6. Adjust selector lever cable and check adjust-
menI (see pages
31
- 11 EO
31
-
12).
lnslalling
1. Arrach cable sleeve on selecror lever base,
tightening the hexagon nut carefully.
2. Push cable on 10 selector lever pin and insrall
circlip.
3. Mount wire. pulled forward during removal,
on cable and pull cable roward rear.
Selector lever cable musk be routed underneath
a meral tab, which is mounted on convener
housing with a hexagon screw.
4. lnsrall selector lever base (warching mark)
and tighten the mounring screws.
31
- 10
Removing and lnsralling Selecror Lever Cable
Primed in Germany