Porsche 928 Workshop Manual page 777

928 Automatic Transmission / Conrrols. Case
37
Assembling
Use specified ATF on bearings and moving parts
when assembling the transmission.
1. Install ourput shaft wirh ball bearings in rrans-
mission case and drive in wirh a plastic hammel
2. lnsrall parking lock gear.
3. Arrach final drive housing with cenrrifugal
governor. modulation pressure valve housing
and
pressure piston (see page 37 21).
4. Install the shims (either those noted while dis-
assembling or those of redetermined rhickness)
with the bearing assembly and righten drive
pinion nur to specified torque (see pages 39 - 23
and 39 - 29).
5. lnsrall brake band B 2 (steel band with radial
groove liner) and brake band guide in tram-
mission case.
F,, ~GTi,;. -'""1
_ D
J..
/ ',:-*'
* r,--v%!p, '&-I ;
-
-c" h,
a
_.
,'I
.-. 1
"
7.4
6. Lubricare and install radial bearing.
1. Hold brake
band
B 1 (sreel band with smoorh
liner) on brake band drum wirh the snap ring
for piston of brake band 8 2.
8. Install gear assembly wirh brake
band
B 1. guiding
the supporr lever for the oil distribution sleeve
inro groove of transmission case
When guiding gear assembly into the transmission
case. make sure that segment spline of sun gear on
the output shafr meshes correctly in drum of brake
band B 2.
9. Install input shaft in gear assembly.
10. Install brake
band
B 3 (chick steel band with
radial groove liner) in transmission care from
from. lnserr both pressure pins in brake band
and screw new adjuring screw coated with a
sealant in rransmission case so far. until brake
band is held
Primed in Germany - 111. 1919
Disassembling and Assembling Transmission
31 - 41