Porsche 928 Workshop Manual page 889

928
Differential / Transaxle System
39
Adjusting Drive Plare
To prevent axial loads on crankshaft and consequently addirional loads on crankshaft thrust bearings, the
connections between flywheel and drive plate (distance X) must be checked and adjusted after replace-
mem of engine. central tube, coupling, front converter housing or drive shaft for converwr.
1 = C&lip
2 = Bushing
3 = Coupling flange
4 = Drive plate
5 = Drive shaft
6 = Engine flywheel
7 = Pre-load 0. 3 + 0.2 mm
A = Distance A, engine flange/flywheel mating surface
X = Shim thickness (must be determined again)
Printed inGermany _ Iv. 198O
Adjusting Drive Plate
fAutomatic Transmission)
39 - 51