Porsche 928 Workshop Manual page 754

37
Automatic Transmission / Controls, Case
928
DISASSEMBLING AND ASSEMBLING FRONT CONVERTER HOUSING
Disassembling Assembling
1. Remove circlip and press WI drive flange.
9
i .B
q$i@ 1
! . .
2. Press grooved ball bearing off of drive flange
with Special Tool VW 457.
1. lnstall both circlips in converter housing.
2. Press grooved ball bearing on drive flange against
shoulder with a suitable piece of pipe applied
on bearing inner race.
3.
Hear converter housing to about 120' C/240' F
and press in drive flange with grooved ball
bearing against circlip.
4. lnstall spacer and press in front grooved ball
bearing against circlip with a suitable piece of
pipe applied on inner race.
To prevent the drive flange from moving out while
pressing in rhe bearing, it must be supported from
underneath with a suitable thrlsr pad.
31 - 20 Disassembling and Assembling Front
Converter
Housing
Printed in Germany