Porsche 928 Workshop Manual page 971

928
DifferentiaI/Transaxle System
39
REMOVING AND INSTALLING DIFFERENTIAL
Removing
Note
1. Drain transmission oil.
2. Unscrew joint flange bolt and remove
joint flange.
Preload of the taper roller bearings could
cause tension on the case when tightening
bolts for the side case covers, which later
could impair installation of the rear case
cover. Consequently the rear case cover
should be installed before tightening the
bolts.
Installing
Drive in joint flange seal with Special Tool
9147.
a
Printed in Germany - X, 1984
Removing and Installing
Differential
39 - 205