Porsche 928 Workshop Manual page 1109

928
Automatic Transmission/Controls, Case
72.Set range selector to "N"
position, insert a holding pin
made of 4 mm welding wire (or 4
mm twist drill) through selector
into hole in shift valve casing
and tighten mounting bolts to
8 Nm (5.9 ftlb). Remove holding
pin.
Note:
Once the transmission has been
installed, check settings of cables
for selector lever and control
0
pressure and check modulating
pressure,
reset if necessary.
Printed in Germany
- XVI,1987 Disassembling and Assembling
Transmission
37 - 175