Porsche 928 Workshop Manual page 862

39
Differential,
Transaxle System
928
REMOVING AND INSTALLING FINAL DRIVE FOR AUTOMATIC TRANSMISSION
Removing
1. Remove transmission and take off control pressure
lever.
Note
Be careful not to place any force on lever shaft when
loosening or tightening the mounting screw, to prevent
damage to shaft in transmission. Always counterhold
with a wrench when loosening or tightening (see page
37 - 141.
2. Mount transmission on assembly stand with Special
Tool 9162 and drain oil from final drive.
j .'-.
+,r
- ,JyqpZ; ,
'.\, ,;: ~c ? , i
.I?
1' ;?@yj-=q;
, *i;.
f$
' ;" I$-* - .
_.
.'
; +a@-
3. Engage parking lock and remove collared nut.
4. Pull out bearing assembly with a suitable pullel
k. g. US 1078).
A - M 10 x 30 bolt with centering hole
Installing
1. Install the shims noted before removal or shims
of newly determined thickness on output shaft
together with bearing assembly.
2. Press in bearing assembly with locally made tool.
1 -Bolt from Special Tool 9148
2 -Washer
Note
Use locally made centering pins to facilitate
installation.
39-24 Removing and Installing Final Drive
Printed in Germany
for Automatic Transmission