Porsche 928 Workshop Manual page 659

30
Clutch, Controls
928
REMOVING AND INSTALLING SINGLE-DISK
CLUTCH
'87 MODELS ONWARD
ENGINE TYPE M 28 .41
Removing
l.Detach ground lead from battery.
Z.Remove complete lower engine
guard.
3.Unbolt clutch actuating cylinder,
disconnect clutch hose holder
from oil pan and allow cylinder
to dangle with line connected.
Note:
Never depress the clutch with
actuating cylinder disconnected.
4.Unbolt starter motor, withdraw
and leave on bracket.
5.Unbolt exhaust flanges on left
and right manifolds and detach
air injector.
6.Remove cover from clutch housing.
7.Remove clamping sleeve cap screws
and push sleeve back along
central shaft
II. If
long
clamping sleeve is fitted, remove
plug in central tube to permit
removal of the rear screw.
8.Remove securing screws for guide
tube and push guide tube toward
flywheel.
9.Disengage release lever from
ball joint by pressing lever
down toward flywheel.
lO.Fabricate three sheet-metal
angles (2 tmn thick), if no
angles are installed.
Note:
These improvised angles are used to
tension and position the genuine
Porsche spare parts.
30 - 6b Removing and Installing Clutch,
Single-Disk Clutch,'87 Models Onward
Printed in Germany
- XVI,1987