Porsche 928 Workshop Manual page 933

928 Manual Transmission/Controls, Case
34
a
3.Working on each side alternately,
use a suitable piece of pipe or a
mandrel to drive fully assembled
input shaft over bearjng outer
race as far as it will go.
9.Place reverse idler with needle
cages and spacer in case as
illustrated.
0
0
0
1
4.Insert O-ring for bearing cover,
oil lightly.
5.Install bearing cover and circlip.
0
\
I
lO.Screw centering pins 9321 for
6.Swivel transmission on support
until input shaft points
downward.
installation of the drive pinion
into case and place shims "S3"
in position.
7.Install needle cage and thrust
washer in input shaft.
8.Place synchromesh ring for 5th
gear on clutch body.
a
Printed in Germany - XVI,1987 Disassembling and Assembling 34 - 214 i
Manual Transmission
('87 Models Onward)