Porsche 928 Workshop Manual page 698

34
Manual Transmission/Controls, Case
928
DISASSEMBLING AND ASSEMBLING SELECTOR LINKAGE
Disassembling
Pry ball socket off of ball head. Disconnect bracket,
in so far as it is mounted on the frame tunnel, to
remove the central tube (see "Removing and
Installing Central Tube").
2. Mount bearing unit (selector rod coupling) on
interior selector rod of transmission with
tapered bolt. If applicable, use Loctite No. 270
(see page 34 .8 dl.
3. Assemble guide tube with bracket (guide tube
bearing) and ball socket. Assemble selector
lever, selector rod and guide tube, lubricating
all bearing surfaces with white paste
(AOS 1260006). Don't tighten locknut for
ball socket or selector rod to bearing unit
(selector rod coupling) mounting bolt at this
point.
Assembling
1. Place transmission on a workbench and apply a
piece of wood underneath rear end so that
transmission is approximately horizontal. Bolt on
central tube with 2 bolts and support from
underneath with an universal transmission lift.
34.8f
Disassembling and Assembling Selector Linkage
VI, 1982 - Printed in Germany