Porsche 928 Workshop Manual page 675

928 Clutch, Controls
30
d) Transfer residual unbalance mark of discs
(yellow arrows) to engine side of same
(facilitates assembly work).
4 Mark pressure plate before installing; drive
pressure plate of dowel pin centered clutch on
to centering pins or into intermediate plate
witi, a plastic hammer far enough, so that the
drive plate located between both can still be
moved with short drive shaft (central shaft I).
fl Pressure plate and intermediate plate are also
marked with dots of white paint (residual
unbalance/heavy side), which are mounted
offset 180' (opposite). This must be con-
sidered when replacing one or both parts.
g) Recheck protrusion of centering pins on fly-
wheel (3.5 - 0.5 mm), correcting if necessary.
h) Lubricate parts to specifications (see table);
however lubricate the starter ring after
installation of the clutch. Don't forget to
lubricate guide tube for the release bearing.
-
a
Printed in Germany -
VI, 1982
Disassembling and Assembling Clutch 30.19
(Diameter and Dowel Pin Centered)