Porsche 928 Workshop Manual page 919

34
Manual Transmission/Controls, Case
928
13. Move reverse gear to correct installed
position with a suitable tool, remove
centering pins 9321 for bearing
assembly and turn latter together with
shims until the reverse gear shaft can be
mounted.
.
14. Drive in reverse gear shaft only far
enough that thrust washer can be
installed. Then drive in reverse gear shaft
to correct installed position and install
clamp.
1 = Clamp
2 = Thrust washer
15. Turn bearing assembly and shims S3 to
installed position, tighten mounting bolts
to torque of 30 Nm and remove Special
Tool 9144.
16. Move countershaft to correct installed
position and install shaft with O-ring
(O-ring coated lightly with oil).
Note
Facilitate installation by turning
transmission on assembly stand until
countershaft falls into correct installed
position on its own weight.
34 - 212 Disassembling and Assembling Transmission
Printed in Germany