Porsche 928 Workshop Manual page 856

39
Dlfferential/Transaxle System
928
ADJUSTING RING GEAR (Stat.)
The drive pinion must not be installed for this
adiustment.
5. Calculate shim thickness Xot.".
Stat. = gap - 0.30 mm (bearing pre-load)
Example:
Gap
1.25 mm
Bearing pre-
lOad - 0.30 mm
1. Install differential with ring gear in case.
sm. 0.95 mm
_----------.
2. Install ride transmission cover (ring gear end)
without shims and tighten all bolts to specified
torque.
3. Guide in second side transmission cover withouj
shims carefully.
4. Check gap between transmission case and side
transmission cover with a feeler gauge.
39 - 18
Adjusting Drive Pinion and Ring Gear
Printed in Germany