Porsche 928 Workshop Manual page 749

37
Auromaric Transmission / Controls. Case
928
ADJUSTING THROTTLE PRESSURE CABLE
1. Detach cable ar trans. lever.
2. Adjust lever with adjusting bolt A after
loosening clamping bolt B so rhz cable can
be attached wirhour tens& or free play.
Caurion
If clamping bolt B is loosened for
adjurrmenrs.
under no circumstances should bolt be tightened
againsr stop inside transmission (damager opera-
ting lever). Use second wrench.
A - adjusring bolt
B - clamping bolt
Ball socket of cable musr be screwed on threads
approx. 6 mm (l/4 in.).
When cable is adjusted correcrly. trans. lever
wave1 will be approx. 33 mm (1 5/16 in.) as
accelerator pedal is depressed from idle IO full
throrrle (not kickdown).
37 - 14
Adjusting Throttle Pressure Cable
Printed in Germany