Porsche 928 Workshop Manual page 750

-
a
a
9 28 Auromaric 'Transmission I Conrrols, Case 37
CHECKING NEUTRAL/PARK STARTING
REM01 ING NELlTRAL/PARK STARTING
SWITCH SWITCH
Starter should only operate in P or _N posirions with
-
properly adjusted swirch.
1. Place selector lever in N position
2. Disconnecr electrical plug
ADJUSTING NEUTRAL/PARK STARTING 3. Remove clamping bolrz and pull operaring
SWITCH lever 1 (wirh attached driving dog) off shafr 5
1. Move selector lever [o posirion N.
4. Remove swirch mounting bolts and withdraw
switch.
2. Loosen adjusting screw.
INSTALLING NEUTRAL/PARK STARTING
3. Inserr 4 mm dia. pin from I!S 8030 tool set SWITCH
through drive dog into locaring hole in case.
1. lnsrall switch and mounting bolts for same.
2. Place operating leveri (with attached driving
dog) onto shaft 5.
3. Inseri lugs of driving dog into swirch.
4. lnserr clamping bolr 3 inro operating lever 1
and righten nur.
1 = operating lever
2 = adjusringscrew
3 = clamping bolt
4 = locaring pin (from US 8030 rool set)
5 = shaft
5. Connect elecrrical plug.
6. Adjust switch.
4. Tighten adjusting screw. Remove locating pin
5. Check wherher engine can be started with
selector lever in N 01 P positions.
- -
Printed inGermany - II. 1919 Neurral/Park Srarring Swircii
37 - ,5