Porsche 928 Workshop Manual page 688

'128
Torque Converler
32
Installing
%b
r 4,
7
'L _
&. c 7;.
.
PJore
*
If ATF contains clutch plare/brake band facing
particles, clean inside of torque converwx with
Special Tool 9310 (flushing mandrel). Fill con-
vertex with about 1 lirer/quarr of kerosene. insrall
flushing mandrel and turn same with a drill
running at slow speed. Repeal these procedures
twice and ler the fluid drain through rhe drain
Plug.
If there are metal panicles in oil rump of trans
mission. rorque converter will have 1" be re-
placed.
4. Run in conveyer carefully. turning it back and
forth slighrly. Also be careful nor I" damage
seal while running in converter.
1. Mount Special Tool 9301 on converter.
2. Lubricate input flange and bearing journal of
converter with a multi-purpose grease con-
raining MoS2 additives.
5. Measure installed depth (about 49 mm) of con-
vener. I" make sure that converrer is positioned
correctly. Install from converter housing.
3. Place transmission upright. Position drive dog
on convener input flange opposite impeller
for engagement.
Primed inGermany - ill, 1930
Removing and Insralling Torque Converrer
32 - 5