Porsche 928 Workshop Manual page 837

38
Auromatic Transmission / Gears. Valve Body !I 28
Assembling
1. Install guide ring for springs and outer plate
rhar shouldered side faces snap ring.
2. lnsrall corrugated snap ring.
Note
The corrugated snap rings of clutches K 1 and
K 2 are different in spring force, for which reason
they must not be mixed up.
3. Assemble plares according to explosion view
drawing and install assembly in outer plare
carrier.
New coated plares must be dipped briefly in an
ATF bath prior to installation.
Measure distance "b" from upper edge of outer
0
plare carrier to bearing surface of support Lange
with a depth gauge.
Clurch play '7" is a - b
If applicable, adjust play by selecting ouwr
plates of pertinent thickness.
4. Che:k clurch play "L". which should be
l.O-0.2mm.
5. Place all springs on guide pin.
Place clutch piston on plate assembly and
measure distance "a" from upper edge of ouer
plate carrier 10 clurch body wirh a deprh gauge.
6. Install seal carefully that it fits properly in the
groove and its sealing lip faces down (in direc-
rion of arrow).
,
3.8 - 50 Disassembling and Assembling Clutch K 2
Printed in Germany