Chrysler 1997 Stratus Convertible RHD Service Manual page 145

MASTER CYLINDER
LEFT STRUT TOWER SPEED CONTROL SERVO
JX
REMOVAL AND INSTALLATION (Continued)
BRAKE PEDAL
REMOVE
(1) Remove the remote ground cable from the
ground stud located on the left strut tower (Fig. 116).
Fig. 116 Ground Cable Attachment At Strut Tower
NOTE: Step 2 2 below is to be done to prevent the
accidental grounding of the remote ground cable.
(2) Correctly isolate remote ground by installing
the ground cable insulator on the strut tower ground
stud as shown (Fig. 117)
Fig. 117 Correctly Isolated Remote Ground Cable
(3) Remove the stop lamp switch from the brake
pedal bracket. Stop lamp switch is removed using the
following procedure. Depress and hold the brake
pedal while rotating stop lamp switch (Fig. 118) in a
counter-clockwise direction approximately 30 degrees.
(4) Remove the retaining clip (Fig. 119) from the
brake pedal pin using following procedure. Position a
small screwdriver (Fig. 119) between the center tang
on the retaining clip and the brake pedal pin. Rotate
blade of screwdriver enough so center tang on retain-
REMOTE GROUND CABLE LEFT GROUNDSTUD AIR CLEANER GROUND TOWER STRUT STUD STRIKER BRAKE LIGHT SWITCH BRAKE PEDAL
ing clip can pass over end of brake pedal pin (Fig.
119). Then pull retaining clip off brake pedal pin.
Fig. 119 Brake Pedal Retaining Clip
(5) Remove the nut from the brake pedal pivot pin.
(6) Remove bake pedal pivot pin from the brake
pedal and pedal mounting bracket.
(7) Remove brake pedal from mounting bracket.
INSTALL
(1) Lubricate the brake pedal pivot pin and brake
pedal bushings using Mopar Lubriplate or an equiv-
alent.
(2) Install the brake pedal in the pedal bracket.
Align the pivot pin hole in brake pedal with pivot pin
holes in pedal bracket.
(3) Install nut on brake pedal pivot pin. Tighten
pivot pin attaching nut to a torque of 34 N·m (25 ft.
lbs.).
(4) Install the vacuum booster push rod on the
brake pedal pin.
BRAKE PEDAL PIN INPUT ROD BRAKE PEDAL RETAINING CLIP SCREWDRIVER
Fig. 118 Stop Lamp Switch
SWITCH BRACKET
BRAKES 5 - 43