Chrysler 1997 Stratus Convertible RHD Service Manual page 143

TRANSAXLE DIPSTICK TUBE DIPSTICK VACUUM HARNESS POWER
JX
REMOVAL AND INSTALLATION (Continued)
(11) Remove the routing clip and chassis brake
tubes (Fig. 110) (as an assembly) from the
(12) mounting stud for the master cylinder.
(13) Remove the master cylinder from the vacuum
booster.
(14) Remove the vacuum harness connector and
electrical connector from the purge solenoid (Fig.
111). Remove bracket and purge solenoid as an
assembly from the vehicle.
Fig. 111 Purge Control Solenoid
(15) Remove dipstick tube attaching bolt (Fig.
112). Then remove the dipstick tube and dipstick
(Fig. 112) as an assembly from the transaxle.
Fig. 112 Transaxle Dipstick Tube
BRAKE BOOSTER VACUUM ELECTRICAL CONNECTOR PURGE SOLENOID TRANSAXLE ATTACHING BOLT
(16) Remove the vacuum hoses from the check
valve located on the power brake vacuum booster.
(17) Locate the power brake vacuum booster input
rod to brake pedal attachment under instrument
BRAKE PEDAL BRAKE P EDAL
panel. Position a small screwdriver between the cen-
ter tang on the power brake booster input rod to
brake pedal pin retaining clip (Fig. 113). Rotate
screwdriver enough to allow retaining clip center
tang to pass over end of brake pedal pin. Then pull
retaining clip off brake pedal pin. Discard retain-
ing clip. Replace only with a new retaining clip
when assembled.
Fig. 113 Input Rod Retaining Pin
(18) Remove the 4 nuts attaching the vacuum
booster to the dash panel. Nuts are accessible from
under dash panel in area of the steering column and
pedal bracket assembly (Fig. 114).
Fig. 114 Vacuum Booster Mounting
BRAKES
BOOSTER POWER SCREWDRIVER INPUT ROD MOUNTING BRAKE NUTS RETAINING CLIP BRAKE PEDAL PIN
5 - 41