Chrysler 1997 Stratus Convertible RHD Service Manual page 183

JX
REMOVAL AND INSTALLATION (Continued)
CAUTION: If speed sensor head locating pin has
seized to the steering knuckle, do not attempt to
remove speed sensor head by grasping with pliers
and turning. This will damage the speed sensor
head. Use only the following procedure.
(6) If speed sensor head can not be removed from
steering knuckle by hand, the locating pin on the
speed sensor head has seized to the steering knuckle
do to corrosion. Remove speed sensor head from
steering knuckle using the following procedure.
Remove disc brake caliper from steering knuckle, and
remove brake rotor from hub/bearing assembly. Then
insert a pin punch through hole in front steering
knuckle (Fig. 34) and tap speed sensor head locating
pin out of steering knuckle.
Fig. 34 Speed Sensor Head Removal From Steering
INSTALL
CAUTION: Proper installation of wheel speed sen-
sor cables is critical to continued system operation.
Be sure that cables are installed in retainers. Fail-
ure to install cables in retainers as shown in this
section may result in contact with moving parts
and/or over extension of cables, resulting in an
open circuit.
(1) Connect the wheel speed sensor cable connector
to the vehicle wiring harness (Fig. 32).
(2) Install the speed sensor cable assembly grom-
met into the front inner fender (Fig. 31). Install
speed sensor cable grommet retainer/routing bracket
on the inner fender of the vehicle and install and
securely tighten attaching bolt (Fig. 31).
CAUTION: When installing the wheel speed sensor
cable routing bracket on the steering knuckle, (Fig.
31) the speed sensor cable must be looped toward
the shock absorber as shown in (Fig. 35). If speed
Knuckle
sensor cable is not routed in this direction it will
rub against the tire or wheel, damaging the speed
sensor cable.
Fig. 35 Correct Front Wheel Speed Sensor Cable
(3) Install the speed sensor cable routing bracket
on the steering knuckle. Install and tighten routing
bracket mounting bolt to a torque of 12 N·m (105 in.
lbs.)
(4) Install speed sensor head on steering knuckle
(Fig. 36). When installing speed sensor head on steer-
ing knuckle, apply a small amount of grease on speed
sensor locating pin (Fig. 36). Use Mopar, Multi-Pur-
pose Grease or an equivalent on speed sensor head
locating pin. Install the speed sensor head attaching
screw and tighten to a torque of 6 N·m (55 in. lbs.).
Fig. 36 Installing Speed Sensor Head In Steering
(5) Install the wheel and tire assembly on vehicle.
(6) Road test vehicle to ensure proper operation of
the base and ABS systems.
BRAKES
Routing
Knuckle
5 - 81